D-Link DFE-530TX PCI Fast Ethernet Adapter Packet Driver Installation for FTP PC/TCP Getting Started --------------- Two methods can be used: METHOD 1: --------- - If the DLKFET.SYS program is used, the following statement must be included in your CONFIG.SYS file: DEVICE = DLKFET.SYS [-option] Note: Before the driver v4.10, the syntax is: DEVICE = DLKFET.SYS [/option] is the software interrupt vector number used by the packet driver program. This can be from 96 to 128. -d Delay Initial - The driver program will not initialize the network interface card until the packet driver program is accessed by its upper layer program. -w The -w parameter is used only in the Windows environment. Please refer to \PKTDRV\README.TXT for the other parameters METHOD 2: --------- - If the DLKFET.COM program is used, follow these steps: - Execute DLKFET.COM by typing: >DLKFET [-option] Note: Before the driver v4.10, the syntax is: DLKFET [/option] is the software interrupt vector number used by the packet driver program. This can be from 96 to 128. -d Delay Initial - The driver program will not initialize the network interface card until the packet driver program is accessed by its upper layer program. -w The -w parameter is used only in the Windows environment. Please refer to \PKTDRV\README.TXT for the other parameters - Execute the ETHDRV.EXE and IDRIVE.EXE device driver programs. These programs are provided by FTP. - FTP's PC/TCP and associated programs are ready to use.