D-Link DFE-530TX PCI Fast Ethernet Adapter Packet Driver Installation for IPX SHELL Getting Started --------------- There are two methods for running the IPX SHELL program. They are described below. METHOD 1: --------- - If the DLKFET.SYS program is used, the following statement must be included in your CONFIG.SYS file: DEVICE = DLKFET.SYS [-option] Note: Before the driver v4.10, the syntax is: DEVICE = DLKFET.SYS [/option] is the software interrupt vector number used by the packet driver program. This can be from 96 to 128. -d Delay Initial - The driver program will not initialize the network interface card until the packet driver program is accessed by its upper layer program. -w The -w parameter is used only in the Windows environment. Please refer to \PKTDRV\README.TXT for the other parameters - Modify the content of AUTOEXEC.BAT to add DPDIPX statement: >DPDIPX >NETX > >LOGIN METHOD 2: --------- - If the DLKFET.COM program is used, follow these steps: - Execute DLKFET.COM by typing: >DLKFET [-option] Note: Before the driver v4.10, the syntax is: DLKFET [/option] >DPDIPX >NETX > >LOGIN is the software interrupt vector number used by the packet driver program. This can be from 96 to 128. -d Delay Initial - The driver program will not initialize the network interface card until the packet driver program is accessed by its upper layer program. -w The -w parameter is used only in the Windows environment. Please refer to \PKTDRV\README.TXT for the other parameters